Home  |  Xena Networks  |  Absolute Analysis  |  Bridge Tech.  |  QoE Systems   |  Telebyte  |  Bluelight  |  ARGUS  |  Elektronika  |  ODM |  Other TestTools  |  Contact

Check RX/ TX pairs of 1000base network cables

In Australia Phone: (03) 9023 0189

International Phone: +613 9023 0189

In Australia Fax: (03) 9700 0583

International Fax: +613 9700 0583

General Enquiry: info@telecomtest.com.au

Accounts: accounts@telecomtest.com.au

To contact us:

Gigabit Loopback

Back to SuperLooper™ Line

Have you ever needed to quickly check a network cable for continuity? Locate which switch port corresponds with a particular wall jack? If you answered "yes" to these questions then you need the Ethernet Loopback Jack. It's a small RJ-45 modular plug like you'd find in a wall jack. You can connect one end of a network cable to a switch port and the other end to the loopback jack, and if the RX/ TX pairs in the cable are good you'll get a link light on the switch or router. So, this gives you a quick and easy way to test network cabling.

You can also take the loopback jack to a wall outlet and when it's connected the corresponding link light on the switch will come on. This allows you to easily match-up a wall jack with a switch port back in the server room.

The SuperLooper™ Gigabit Loopback Jack and Plug is backward compatible with 10base and 100base networks.

· The loopback jack can be used to test Ethernet pairs

· Can also be used to match an outlet on a switch hub with a wall jack

· This jack can be used in conjunction with other Ethernet test equipment

· Small, very portable, easy to use

· Comes with small chain for connecting to your keyring, backpack, tool bag, etc.

· Compatible with Gigabit and 10/100 Ethernet

 

General 
Dimensions:       2.03 X 0.69 X 0.76 (inches) 
Weight:               12 grams 
Color:                 Purple 
Regulatory:        Compliance CE

 

Wiring
 

FROM RJ-48C Jack		TO RJ-48C Jack
1		3
2		6
4		7
5		8
FROM RJ-45 Plug		TO RJ-45 Plug
1		3
2		6
4		7
5		8

Note: Not all Gigabit Ethernet systems support loopback operation. The SuperLooper™ Gigabit Loopback Jack & Plug use is intended solely for testing systems where the Near End Crosstalk (NEXT) function can be disabled and the equipment under test can support being looped back to itself. Consult the manual of the equipment being tested to determine if Gigabit loopback function is supported.

$18.00 AUD Inc. 10% GST (Qty Disc. Available)

 Home